RX7Club.com - Mazda RX7 Forum - Search Results

 
Search: Posts Made By: 13btnos
Showing results 1 to 25 of 459
Search took 0.46 seconds.
02-17-19, 04:30 PM
Replies: 3
Views: 1,107
Posted By 13btnos

Sounds like you've already done the homework but...

Sounds like you've already done the homework but I've used most of the seals you've mentioned. Goopy and RA seem to be harder on the housings. The E&J and Atkins seem to be easier on the housings but...
11-04-18, 01:52 PM
Replies: 2
Views: 727
Posted By 13btnos

Just get 4 ID 1700's and call it a day it will...

Just get 4 ID 1700's and call it a day it will cover your to 500rwhp because you will always want more later anyways and from what I've seen they are very controllable and shouldn't hurt your idle.
10-25-18, 11:04 PM
Replies: 15
Views: 2,459
Posted By 13btnos

Rotella 15w40 bearings are always perfect just...

Rotella 15w40 bearings are always perfect just change it more often it's cheap anyways.
10-06-18, 09:50 PM
Replies: 8
Views: 1,479
Posted By 13btnos

You running water injection with no intercooler?...

You running water injection with no intercooler? Nice setup, how much boost and how many injectors? I've been wanting to ditch my intercooler but haven't seen too many doing it on rotarys especially...
10-06-18, 09:39 PM
Replies: 3
Views: 485
Posted By 13btnos

Did you rotate it with the front stationary not...

Did you rotate it with the front stationary not in place? If so place the stationary back and rotate till it lines up and you can bolt it down. Should not be an issue its just a matter of getting the...
07-25-18, 10:48 PM
Replies: 21
Views: 2,478
Posted By 13btnos

http://paradiseracing.com/shop/13b20bmazda/paradis...

http://paradiseracing.com/shop/13b20bmazda/paradise-racing-rons-1-5-mech-fuel-pump-kit/ I wouldn't even waste your time or money buy once cry once because you will eventually end up going mechanical.
Forum: Microtech
02-25-18, 11:39 AM
Replies: 9
Views: 937
Posted By 13btnos

Microtech runs both high and low you'll be fine...

Microtech runs both high and low you'll be fine drive it easy to the dyno but if in doubt just tow it.
Forum: Microtech
02-21-18, 09:32 PM
Replies: 3
Views: 876
Posted By 13btnos

You'd have to use these High Output Inductive...

You'd have to use these High Output Inductive "Dumb" Coil (http://www.aemelectronics.com/products/ignition-components/high-performance-coils/high-output-inductive-dumb-coil)
02-21-18, 09:21 PM
Replies: 11
Views: 4,872
Posted By 13btnos

You didn't screw anything up what's more of a...

You didn't screw anything up what's more of a restriction is your stock manifold https://www.rotary-works.com/intake-throttle-body/RW-IM-COSMO-4 I'd look into this it will flow a whole lot better. I...
02-12-18, 10:58 PM
Replies: 3
Views: 841
Posted By 13btnos

MSD 6A direct fire Ignition for Mazda RX-7 Rotary...

MSD 6A direct fire Ignition for Mazda RX-7 Rotary Engine - Dr. Scott M. Baker (http://www.smbaker.com/sand-rail/mazda-rotary-conversion/msd-6a-direct-fire-ignition-for-mazda-rx-7-rotary-engine)
12-02-17, 10:33 PM
Replies: 11
Views: 2,469
Posted By 13btnos

https://www.facebook.com/microtechefi/ scroll down

https://www.facebook.com/microtechefi/ scroll down
12-02-17, 08:40 AM
Replies: 11
Views: 2,469
Posted By 13btnos

Billet plates SemiPport 88-94mm turbo Microtech...

Billet plates SemiPport 88-94mm turbo Microtech and a shitload of fuel and spark. I was just there in FL at OSW last weekend and had the pleasure of checking some of the cars and the core of the...
09-10-17, 10:24 AM
Replies: 1
Views: 830
Posted By 13btnos

There are plenty of people running hi comp rotors...

There are plenty of people running hi comp rotors in a boosted application really no need to swap out rotors. S4 n/a comp is 9.4 S5/S6 turbo is 9.0 hell there guys boosting rx8 motors and they are...
09-02-17, 02:21 PM
Replies: 1
Views: 891
Posted By 13btnos

They use EV1 injectors basic old school bosch...

They use EV1 injectors basic old school bosch white tops/ indy blues. You can use EV14 but must have the correct hat to make them the same length as the EV1 injectors and be 14mm orings.
08-20-17, 11:54 AM
Replies: 99
Views: 11,470
Posted By 13btnos

Congrats!!! Times are going to keep dropping good...

Congrats!!! Times are going to keep dropping good luck, have fun and be safe.
07-17-17, 11:58 PM
Replies: 7
Views: 1,537
Posted By 13btnos

Calculations...

Calculations (http://www.maxcooper.com/rx7/how-to/fuel_system/calcs.html)
07-17-17, 11:55 PM
Replies: 99
Views: 11,470
Posted By 13btnos

What 2200 injectors are you using? Man that 8...

What 2200 injectors are you using? Man that 8 second pass should be in the bag for you just by dropping the weight.
Forum: Microtech
07-15-17, 10:41 AM
Replies: 4
Views: 1,046
Posted By 13btnos

Switched 12V, usually power when you turn your...

Switched 12V, usually power when you turn your ignition on. One way to do it is to run a relay and use your ignition switch to turn that relay on and then run the main load wire from the relay to a...
07-03-17, 12:07 PM
Replies: 8
Views: 1,267
Posted By 13btnos

Check the clutch to see if you have too much load...

Check the clutch to see if you have too much load on it. Put trans in 1st push the clutch all the way in and rev it to redline if the car lurches forward with the clutch in it is too tight and need...
06-12-17, 11:03 PM
Replies: 44
Views: 6,940
Posted By 13btnos

Billet Inc. ? Home of the World's Fastest Rotary...

Billet Inc. ? Home of the World's Fastest Rotary Engines (http://www.billetinc.com.au/) Well these have been around for a while now and are proving to be very good and reliable. My buddy in Florida...
05-27-17, 09:34 AM
Replies: 5
Views: 1,833
Posted By 13btnos

I use the exact one you linked to and just use...

I use the exact one you linked to and just use the abrasive supplied with it. Works great I clean my plugs after each drag event I run. They come out looking like new just make sure you blow all the...
Forum: Microtech
04-29-17, 11:12 AM
Replies: 1
Views: 728
Posted By 13btnos

Siemens Deka 220lbs

https://www.fiveomotorsport.com/fi114212-110333-220lbs-deka-iv-long-mimitimer Has anyone ran these with their Microtech? They are low resistance at 2.27 Ohms so I was looking to use them as Aux...
04-29-17, 10:56 AM
Replies: 14
Views: 958
Posted By 13btnos

First question is what's your use of the car?...

First question is what's your use of the car? Daily driver, street car, weekend track car? If the majority is street driving then stick with a street port and a larger turbo and more boost. You will...
Forum: Build Threads
04-14-17, 10:20 PM
Replies: 39
Views: 8,406
Posted By 13btnos

Just wondering what is your base fuel pressure...

Just wondering what is your base fuel pressure set at and what type and how many injectors are you running? I have the same Eliminator pump and people say they don't like high pressure. I'm also on...
04-14-17, 12:01 AM
Replies: 253
Views: 34,776
Posted By 13btnos

I run the tried and true MSDDIS4HO's guys drag...

I run the tried and true MSDDIS4HO's guys drag racing on the east coast and Puerto Rico have been running this setup forever....
Showing results 1 to 25 of 459
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.