RX7Club.com - Mazda RX7 Forum - Search Results

 
Search: Posts Made By: GSLSEforme
Showing results 1 to 25 of 101
Search took 0.03 seconds.
07-13-19, 09:29 PM
Replies: 6
Views: 261
Posted By GSLSEforme

Remove relay held in place by rubber boot on side...

Remove relay held in place by rubber boot on side of headlight motor. Disconnect harness connector. Carefully open up relay by removing shell and inspect contact points inside relay to see if...
07-12-19, 11:17 PM
Replies: 36
Views: 1,275
Posted By GSLSEforme

https://cimg6.ibsrv.net/gimg/www.rx7club.com-vbull...

https://cimg6.ibsrv.net/gimg/www.rx7club.com-vbulletin/1500x2000/img_0136_fc16547cad93ae0c9a046796f08f6cedc1abcb36.jpg...
07-10-19, 09:58 PM
Replies: 36
Views: 1,275
Posted By GSLSEforme

Ray,consider using R152. Performance is much...

Ray,consider using R152. Performance is much closer to R12 than is R134.
06-27-19, 07:11 AM
Replies: 21
Views: 980
Posted By GSLSEforme

I have"fixed" this condition on several cars by...

I have"fixed" this condition on several cars by wiping complete extended mast down with acetone. A lot of gunk gets built up in the sheaves on sections of mast. Lightly dribble a light lubricant, i...
06-24-19, 04:29 PM
Replies: 3
Views: 427
Posted By GSLSEforme

Socket may be corroded but can be cleaned up...

Socket may be corroded but can be cleaned up easily.
Go to Lowe’s or Homies and get a brush used in cleaning up inside of 1/2” copper pipe before flux and sweating,perfect size for cleaning out...
06-14-19, 08:40 PM
Replies: 71
Views: 3,590
Posted By GSLSEforme

Thanks Tim. I was trying to do things a certain...

Thanks Tim. I was trying to do things a certain way, Did a lot of bench testing ig.modules,coils. Of all the coils i tested With the Pertronix modules the FC coil had the most grunt. I tested all the...
06-12-19, 02:10 AM
Replies: 71
Views: 3,590
Posted By GSLSEforme

The flame thrower is a hi amp HEI ignition module...

The flame thrower is a hi amp HEI ignition module made by Pertronix.
Perhaps you should revisit wherever you read here that doing a DFI conversion is a mistake and who posted that.If you read the...
06-11-19, 08:31 PM
Replies: 7
Views: 949
Posted By GSLSEforme

Keep the 200 for DD and lowball seller of...

Keep the 200 for DD and lowball seller of RX,since not running,see what he says. Include engine/trans in deal,offer $1000.00
06-11-19, 08:24 PM
Replies: 7,050
Views: 523,139
Posted By GSLSEforme

Turn heater temp all the way to hot. While engine...

Turn heater temp all the way to hot. While engine still somewhat cold,position car uphill as much of an angle. Be sure rad full and coolant catch tank up to max . Run engine at a fast idle 1800 rpm...
06-09-19, 08:45 PM
Replies: 38
Views: 2,089
Posted By GSLSEforme

No intention of contradicting your"no modern...

No intention of contradicting your"no modern dizzy conversion crap"...as periphery functions that're rock solid and relatively inexpensive go,an FB electronic ignition conversion is top of this list...
05-30-19, 11:04 AM
Replies: 40
Views: 1,812
Posted By GSLSEforme

^^^lol

^^^lol
05-30-19, 09:13 AM
Replies: 40
Views: 1,812
Posted By GSLSEforme

1st,nothing personal-so don't take it that...

1st,nothing personal-so don't take it that way...45+years in the business of maintaining,repairing,restoring automobiles,motorcycles so you know where i'm coming from. Til @ 20 years ago Fram filters...
05-28-19, 03:09 PM
Replies: 18
Views: 1,121
Posted By GSLSEforme

There's a reason 5 people that responded to your...

There's a reason 5 people that responded to your thread all recommended to replace the factory style idler arm-regardless of the fact it was new-with the Moog unit you listed in your original post....
05-24-19, 08:15 PM
Replies: 24
Views: 977
Posted By GSLSEforme

For a normally driven stock street car,beehive...

For a normally driven stock street car,beehive cooler is more than adequate. Hp adders,turbo,track days,FMOC is recommended.
05-24-19, 04:17 PM
Replies: 56
Views: 2,579
Posted By GSLSEforme

Any time you have exhaust glowing-it is not...

Any time you have exhaust glowing-it is not normal.
You have a seriously out of balance air/fuel ratio,glowing exhaust indicates severely lean running condition with super high temps in combustion...
05-22-19, 07:30 AM
Replies: 56
Views: 2,579
Posted By GSLSEforme

https://cimg2.ibsrv.net/gimg/www.rx7club.com-vbull...

https://cimg2.ibsrv.net/gimg/www.rx7club.com-vbulletin/800x800/img_1662_6fe5d0380f98b4ccdc7e90be2d18bff156846a12.jpg...
05-21-19, 09:11 PM
Replies: 20
Views: 947
Posted By GSLSEforme

So many experts out there....have you checked...

So many experts out there....have you checked level and condition of atf YOURSELF? Very 1st thing to be checked is fluid level/quality when trans has delayed engagement. Listening to people who have...
05-18-19, 06:22 AM
Replies: 6
Views: 562
Posted By GSLSEforme

Air itself doesn't cause corrosion(long...

Air itself doesn't cause corrosion(long term),it's the moisture that gets into the system over time that causes corrosion and is reason why brake fluid should be flushed @every 2 years,30k miles....
Forum: Build Threads
05-17-19, 10:30 PM
Replies: 110
Views: 12,143
Posted By GSLSEforme

I see what you did there,lol

I see what you did there,lol
05-17-19, 10:17 PM
Replies: 6
Views: 504
Posted By GSLSEforme

Follow testing suggestions in sequence so you’re...

Follow testing suggestions in sequence so you’re not chasing your tail...
I don’t think you’ll find the trailing vac advance can to be source of your problem.
Don’t pigeon hole yourself into...
05-08-19, 09:44 PM
Replies: 56
Views: 2,579
Posted By GSLSEforme

https://cimg7.ibsrv.net/gimg/www.rx7club.com-vbull...

https://cimg7.ibsrv.net/gimg/www.rx7club.com-vbulletin/800x800/img_1660_ed2cbf1d38892c3fdb7553be573d279c21eef11e.jpg
Cranking it for a "while" is pulling in more gas each revolution the engine...
05-07-19, 03:36 PM
Replies: 56
Views: 2,579
Posted By GSLSEforme

Don’t worry about the shield,thought maybe you...

Don’t worry about the shield,thought maybe you left it off.
Understood on timing marks.
If dist holdown bolt in center of slot,turn dist ccw a bit more and lock it down there.
05-06-19, 12:03 PM
Replies: 56
Views: 2,579
Posted By GSLSEforme

The trailing coil is the most forward mounted...

The trailing coil is the most forward mounted coil and its high tension wire goes to trailing coil wire position on distributor cap.
If the engine static timing is correct and if when running seems...
04-27-19, 09:20 PM
Replies: 7,050
Views: 523,139
Posted By GSLSEforme

aeenox,the inner bearing race and bearing...

aeenox,the inner bearing race and bearing retainer are a press fit on axle and are pressed on to the shoulder machined in the axle and cannot be pressed"too far". The "race" you're describing is the...
04-14-19, 11:40 AM
Replies: 11
Views: 587
Posted By GSLSEforme

Replace the fan clutch,it is defective,you're not...

Replace the fan clutch,it is defective,you're not wasting your money.
Showing results 1 to 25 of 101
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.