Which RteK chip for 6 port turbo?
Is it possible to use an RteK chip on an N350 or N351 ECU for a 6 port turbo engine?
|
on a n333 i use to use 1.5 with a hi flow fuel pump and raising rate fpr and of course all tii electronics. but you are running higher compression on the s5.
im now running 2.1 same setup and running good. |
If you turbo an NA, you should use the turbo ECU, MAP and AFM. The ECU, MAP and AFM must all match. Don't mix NA ECU with turbo MAP/AFM or vice versa.
|
Originally Posted by 3rd and final 7
(Post 10472059)
on a n333 i use to use 1.5 with a hi flow fuel pump and raising rate fpr and of course all tii electronics. but you are running higher compression on the s5.
im now running 2.1 same setup and running good. To the second reply I was wondering if I could get an NA ECU chipped by RteK so I didnt have to get all the turbo stuff but I guess I cant. |
those rotors are still a higher compression than the turbo rotors of any series. As turbo2ltr stated get the turbo ecu, map, and afm. I am running a 6 port turbo as well and have no had any issues with the Rtek 2.1. I suggest you get that one so you have the ability to make adjustments to the map, both fuel and timing. Otherwise in the end you will more than likely end up regretting it.
|
just run all s4 eletronics rtek 2.1 s4 ecu ( ialso used a 1.5 for a while with a raising rate fpr, boost sensor, afm , im also running a walbro 255 and 720 pri and 740 sec injectors and im doing this on a 88 6 port so you should be just fine , or if you have s5 car you would the turbo electronics for a s5
|
Originally Posted by 3rd and final 7
(Post 10488149)
just run all s4 eletronics rtek 2.1 s4 ecu ( ialso used a 1.5 for a while with a raising rate fpr, boost sensor, afm , im also running a walbro 255 and 720 pri and 740 sec injectors and im doing this on a 88 6 port so you should be just fine , or if you have s5 car you would the turbo electronics for a s5
|
All times are GMT -5. The time now is 10:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands