Need Help: logging weirdness
3 Attachment(s)
Hey guys, I was looking for a little assistance here. I got some time on a dyno today to get my car tuned, and I am a little confused with my logs. All the values are seeming very sporadic. I have been poking around at other people's logs and they seem allot smoother; there are a couple of points in the logs where the RPM's even go appear to dip slightly and my wideband is all over the place. the dyno's wideband (tailpipe sniffer) was also reading completely different than mine, and it did not pick up on that super lean spot (which just so happens to correspond with one of those RPM's going backwards moment in the log...) I am running an RTEK 2.1 with a tungsten e2 on what I believe is the latest version of pocket logger (need to confirm). I was wondering if anyone had seen this before or has any ideas on what is going on here, any feedback would be much appreciated as I am not sure how much I trust the logging of the RTEK now.
On a positive note I was able to make right under 300 WHP (298) at 11 PSI. Looking to see how far I can push this RTEK setup safely... Car mods are below if anyone is interested. 88 TII Street ported motor (~20K mi) All emissions / rats nest / PS / AC removed Walbro 255 720 Pri/1000 Sec Aeromotive A1000 FPR -6AN SS fuel lines connected to the hard lines MSD Digital 6A Custom FMIC setup 3" Turbo back exhaust with Flowmaster super 44 muffler Hybrid S5 turbo with Garrett T4 .70 A/R housing, ported wastegate SS turbo oil feed line ACT Street light flywheel & stage 3 clutch Polyurethane mounts TEIN RA coilovers Koyo radiator HKS SSQV BOV Retk7 2.1 AEM Wideband Greddy Profec B Spec II Boost Controller GM 120 amp alternator SS Clutch line and some others... |
how old is your sensor? is it in the stock location or further down the downpipe like it should be?
|
Thanks for the reply. Unfortunately I do have the sensor down stream (behind the transmission), and it only has around 1.5 - 2k miles on it.
That being said, I am seeing sporadic logging with every sensor I am logging; if you take a good look at the attached logs you will see places in the RPM range during a 4th gear pull that the RPM's get lower for 1 logging interval, then jump up again. This does not seem right to me, and I have not seen this in any of the other logs I have looked at that other people have posted. |
how much lower does it get. Some "noise" is normal.
|
All times are GMT -5. The time now is 02:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands