Driveshaft shop axles
Just wondering if anyone has used them and how they have held up??
|
I use them. I stripped the splines off of one, they replaced it for free and I haven't had a problem since. 1.47 60'
|
Good to hear. Never felt so helpless when I got to the line, got ready to launch and SNAP. Car was fine on a street tire, once I put the ET streets on I didn't even get to make one pass
|
I have pulled 1.28 60ft so far and i'm sure it's going to get better.
DSS axles are holding up like a champ. Definitely the best way to go.. I got their stage 5 kit. |
1.5 60s with 8500rpm drops. Holding fine.
|
r the driveshaft shop outer stubs same spline like the fd hub?
or r they bigger where machining of the hub is needed? |
Geez im still on my stock axles(with 140k) cutting mid 1.5's low 1.6's, no two step though that just reving around 7500 and dump. Only putting down 475rwhp too. I bought a spare axle from napa and never used it but im sure if i didnt buy it i would have broke it. Already blew my diff once on the ET's.
|
Pro level 1.33 60 ft 2838 lbs
BY FAR THE BEST ON THE MARKET !!!!!:nod: |
All times are GMT -5. The time now is 10:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands