13brew t04b injector sizing
#2
Rotary Motoring
iTrader: (9)
Should be good. I wouldn't call it overkill.
Personally, I would mod the primary rail and put the 2ndaries in the primary spot for 2x 850cc & 2x 1900cc.
I was running 85% duty cycle on 2x 720cc & 2x 1,600cc combo on my smaller HiFi compressor cover 57mm T04B @ 18psi.
Maxed the duty cycle ~3,300rpm on my next 57mm turbo (EFR 7670 on high boost) and had to settle for 26psi.
Then again, my engine likes to run really really rich for best power.
Personally, I would mod the primary rail and put the 2ndaries in the primary spot for 2x 850cc & 2x 1900cc.
I was running 85% duty cycle on 2x 720cc & 2x 1,600cc combo on my smaller HiFi compressor cover 57mm T04B @ 18psi.
Maxed the duty cycle ~3,300rpm on my next 57mm turbo (EFR 7670 on high boost) and had to settle for 26psi.
Then again, my engine likes to run really really rich for best power.
The following users liked this post:
sukimoto (10-14-21)
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM