Air Temp Sensors
Does any on know what the voltage to temp ratio is for either GM or Bousch air temp sensors?
I would like to build a simple temp prob to place before and after the IC and have a small duel display to monitor temps. |
Here you go. I will be using one to PWM my intercooler fan.
http://www.megasquirt.info/index.html Glenn |
Originally Posted by RotaryExperimental
Does any on know what the voltage to temp ratio is for either GM or Bousch air temp sensors?
I would like to build a simple temp prob to place before and after the IC and have a small duel display to monitor temps. |
fatman keep me informed please
|
Here's a device that will satisfy you guys.. and it's less than $30... and runs on 12 VDC..
http://www.hardcorecooling.us/index....ROD&ProdID=655 |
I just tested the resistance of the air temperature sensor in the intake elbow of my 20B. I used the MegaSquirt standard baseline temperature of 81ºF and it was between 27k and 28k.
I don't know how accurate my thermometer is, but being right around 27k is encouraging because it matches MegaSquirt's listing for Ford sensors. Scroll down the page to a little lower than the middle to see the table. http://www.megasquirt.info/manual/mass.htm |
The one's Im making can vary in sensitivity. Depending on the type of wire used to make them. Also if the wire is fit for that temperature range. I still need about a week or two , to finish my project, then I'll let you guys know how it looks and go's.
|
All times are GMT -5. The time now is 10:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands