fd intake manifold
 

i am looking into using an FD intake manifold on an FC engine, i have seen this done often and was curious to as what's involved to have one fit onto the other.

reasons for doing this are the Greddy intercooler pipe adapter and i understand it has a little bit better flow. although, i am also curious as to the fitment of this with an hks cast manifold, ext. gated

all help or at least words of encouragement are apreciated

you do this mod for better flow and the FDs throttle body, not just the intake manifold.

You would need the spacer, which goes between the FD upper intake manifold and the FCs lower intake manifold. A plug for the FD TPS and you must wire that plug to your FC TPS harness. and hardware.

If you want the stuff...let me know, pm me or email me at park56@purdue.edu

If you want the Power Fc for FC3S let me know also.

:)

-joe

There is an adapter plate available that allows you to keep your computer with the fd tb/tps
http://www.rxecret7.com/feedfc-exchkit.html

Can be done without it. Check out this thread for a good write-up about it.
http://www.teamfc3s.org/forum/showth...5&pagenumber=1

Also an issue is the oil filler neck, throttle cable and cruise control.