EGT Probe Location???
what is the current reasoning on locations for EGT Probes?, I am adding weld in bungs to headers.
|
I would just drill it on your down pipe, temps maybe a little lower, but you can still compare the readings.
I never liked drilling into thick exhaust manifolds when the down pipe will do fine. |
I asked the same question on nopistons.com
Answer: about 3-4 inches down the header. |
I've got a twin EGT gauge ... one probe in each runner of my exhaust manifold !
|
How close to the port
I have seen suggestions anywhere from 1" to 6" from the port/header flange
|
I also have a temp probe in each primary runner of the manifold about 1-1/2" to 2" from the port. I have a loggable dual channel setup so I can compare egt's from rotor to rotor.
|
Data Logger
what data logger setup are you using?
|
|
All times are GMT -5. The time now is 11:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands