AI tank placement
 

Im working on my methanol injection setup and i am trying to figure out how to mount everything. The car will see light duty at the track so i want to make sure it will pass tech. How should i go about mounting the methanol tank? I was origonally going to put it in the rear bins. Also, do i need to run one of those plastic fuel cells? I did a bit of searching but i havent come up with much.

Thanks for your help

if you are going to run 100% methanol you need a fuel cell not a plastic jug w a screw-on top. that is fine for water injection and a 50-50 mix which won't burn... not alcohol.

consider it exactly the same as gasoline.

here's what i run along w all stainless steel braided lines and brass fittings..

http://www.jegs.com/webapp/wcs/store...0002_758786_-1

$145 for a 4 gallon cell. more expensive yes, but...

please see my thread regarding compnent location for further help.

https://www.rx7club.com/auxiliary-injection-173/optimized-ai-alcohol-system-component-location-fd-586925/

good luck and i know you will get hooked on the alcohol. i did.

howard coleman