|
reset PowerFC to factory setting. Question about PowerFC reading.
I just reset my PowerFC to factory setting. Idle relearn done. as this thread : https://www.rx7club.com/3rd-generati...needed-841706/ I did almost every step the OP said. Now I got some question about PowerFC reading. Now it shows like this. https://cimg8.ibsrv.net/gimg/www.rx7...81e779b0b.jpeg I wonder if my boost is correct or not it shows +0.5mmhg which I convert to 0.0967psi which is very low. someone please help me |
It reads -401 which is fine. The +.50 is boost which was your peak during your 7400rpm run, that would have been around 7.5 psi. That is low for max boost, but it depends on your other mods
|
2 Attachment(s)
It has been proven that the Settings 3 Pim scale and offset values are wrong. Some of us calibrate the map sensor so that the visual and logged boost pressures
are more accurate. Better to be accurate under boost than idle. |
It's confusing because it says "mmHg" right there, but that's just showing the units for the vacuum reading. If you rev the engine into boost that display will change to "kg/cm2". The peak number is in kg/cm2 which is really close to bar.
10psi is about .7 kg/cm2. Which, BTW, is kilograms of force per centimeter squared :). Dale |
| All times are GMT -5. The time now is 03:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands