Datalogit/Wideband help
 

i got no readings on my datalogit from the wideband. i got voltage readings on the wires from the gauge but nothing on fc-edit on my laptop all i get are 0's. any thoughts>?

Improper wiring and or setup within the DL software.
Read the info for both devices.
Find an experienced user in your area.
Post in the PFC forum, not here.

unfortunately im the only experienced user here lol noone in my are has a pfc or an rx7 theres like 4 here and ive never met the guys

and i poted on here because more rx7 owners see this than the power fc categories

What type of wideband?
How is your wideband wired to the datalogit?
What are your auxiliary setting in FC-Edit?

So I have a 30-4100 aem uego, it's wired with the white cable on AN1 and the black cable I grounded and connected to AN2. The settings I put on the auxiliary are 6.6 and13.2AFR for afr.

When tuning some other cars, think the values were 10 and 20 afr. Look at manual to double check. Ensure values on w/b match or are very close to wide band readings.

So the values I used were 10-20 and I was getting 0s on the map so today I'll be trying the 6-13 values I spoke of since that's what aem specifies for e85

E85 runs much richer. So those values make sense.

In your "Monitor" screen, do you have "Aux A/D" checked in the lower right corner?

AFR is AFR no matter which fuel you use if tuning by AFR.
Now if you are tuning by lambda, then that is different.

can you get me a screen shot i looked but i couldnt find it

nvm i found the box i've checked it so i will give it ashot tomorrow

How do I make my apexi power fc into a boost controller?

this is what i found APEXi 415-A013 Power FC Boost Controller Kit Add-on
and i think maybe through the outputs on the datalogit you might be able to as well

Innovate made a quite good manual for their sensor and how to use it with Datalogit on a RX7 an finally use it to tune :-) . I know you got a AEM , but i thought most of it is generic in any way

LC-1 Integration into Apex Power FC w/Dataloggit Logger:: Innovate Motorsports Application Notes

go to this link there is a PDF on aem widband setup with power fc
http://nyrotorsports.com/

there is a problem with AEM tho you probably wont get gauge and datalogit to read the same...

datalogit was more accurate then the gauge to .1 with lc-1 on the dyno

Shit yeah man! Thanks for sharing this info! Really helped me decide which wideband to get.