rx7 fc 1jz build
#27
Junior Member
Join Date: Apr 2016
Location: Sanford, North Carolina
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
How was your experience with JDM Engine World? Also where did you end up finding your W58 Trans? Thank you in advance. I'm trying to do this swap for my RX 7 as well and just trying to figure everything out.
#28
Sideways is the only way
iTrader: (2)
Join Date: Nov 2007
Location: Vermont
Posts: 958
Likes: 0
Received 0 Likes
on
0 Posts
FWIW, in another 1jz thread on here I saw that the NA version of the mark IV supra had a shifter extension on the trans that will work for the FC. If anyone here is wondering about that. tech 2 motorsports also has a shifter extension but its a little pricey. That was my concern after the mounts themselves.
liking all the info, Still wondering about wiring with the 1jz ecu as far as the interior harness goes. Is everyone just repinning it to the 1jz ecu connector I'm assuming? I'm not great with wire diagrams, I can get by but a "this color FC side goes to this pin JZ side" would be awesome.
liking all the info, Still wondering about wiring with the 1jz ecu as far as the interior harness goes. Is everyone just repinning it to the 1jz ecu connector I'm assuming? I'm not great with wire diagrams, I can get by but a "this color FC side goes to this pin JZ side" would be awesome.
#29
Junior Member
Join Date: Apr 2017
Location: Grand Forks ND
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
FWIW, in another 1jz thread on here I saw that the NA version of the mark IV supra had a shifter extension on the trans that will work for the FC. If anyone here is wondering about that. tech 2 motorsports also has a shifter extension but its a little pricey. That was my concern after the mounts themselves.
liking all the info, Still wondering about wiring with the 1jz ecu as far as the interior harness goes. Is everyone just repinning it to the 1jz ecu connector I'm assuming? I'm not great with wire diagrams, I can get by but a "this color FC side goes to this pin JZ side" would be awesome.
liking all the info, Still wondering about wiring with the 1jz ecu as far as the interior harness goes. Is everyone just repinning it to the 1jz ecu connector I'm assuming? I'm not great with wire diagrams, I can get by but a "this color FC side goes to this pin JZ side" would be awesome.
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM