rx4 trans problem
OK so I need some info, I'm in the process of putting a 13b with a 225mm flywheel and clutch in a 74 rx4 with its factory 4 speed.
Now the problem is, it seems the pressure plate is hitting the bell housing. I can turn the motor by hand then it hits and locks down, I can turn it back the other way and same thing. So is it not possible to use a 225mm clutch with the factory 4 speed? |
It should work. I have a factory 74 REPU 4 speed in a rotary MG Midget with a 225mm pressure plate and it fits perfectly.
|
I'm using an act clutch and pressure plate. But the pursue plate is definitely hitting something in the bell housing, it will only let the engine turn half a rotation by hand. I'm going to pull it back out for the 3rd time now and see if I can find where it's hitting, I'll let you know what I see, this just sucks.
|
Fixed it. On the top of the bell housing right in front of the clutch fork on the inside. There's a little hump that I had to trim down with my angle grinder. Now it turns freely.
|
All times are GMT -5. The time now is 06:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands