Question: To all of those who have done a Rotary engine into a B-Series PU
 

What is needed to do the entire swap into lets say a 87 B2600 PU.

Had this complet set up from a 88 engine, trans, wire harns, PCM, sensor, drive shaft, all of it out of a car that still liked good and ran, there was this realy good clean B2200 down the street, it was not for sale, well as time goes on sold the engine and all the goodes and now the B2200 is for sale, drove by that truck on a daily bases thinking how nice it would go to gether, "O" @#$%^&*So did I anser the quiston

The driveshaft bolts right in? Any engine mounts needed?

The engine mount depends on the year of the engine you're using. 85 and earlier rotaries used a brace that goes across the front of the front cover of the engine. 86 and later cars have the engine mounts on the intermediate housing, right in the middle of the block. You'd want to take a tape measure and look at where your mounts would be and decide what mounts to use after that.

Ill have to check into that. Im just super curious since I found a 87 B2600 (or B2200) with a blown engine and I could find a NA tranny and engine with all the other stuff for pretty cheap. I think it would be fun even without alot of functionality.

It's really just a matter of what fits better where. You could even put an older front cover on an 86-up engine and have your choice of mounts. Do you already have an engine sourced?

dan atkins has done this, i think he used a mount of an SA and turned it upside down and it fit perfect

drive shaft needs to be custom

he has a supercharged 88 i believe