How do ya remove the stock RX2 12a header from the 12a engine block?
1 Attachment(s)
I'm trying to get the old header off of the 12a engine.
I undid the 2 nuts on the top of the header flange where it meets the aforementioned 12a type place. there is still 2 nuts that are impossible to get any tool into for the cavity is too tight you see. i don't usually put just any tool around these nuts but a nice 14mm spanner or socket would be the case, if there was enough room for either, however this situation has proven to be not so fortunate for this here I. i would like to know how people get their rx2 12a exhaust headers off because the only way i can see this happening is... i don't even know..... like angle grinder or something.. hope people can help, i would be forever grateful and i will probably remain in your debt for most of eternity. i will perhaps attempt to attach a photograph documenting my shortcomings. Peace, and happiness be upon you all~ :scratch: Sincerely, from Hozay the rotary guy that likes learning about how to remove an rx2 12a exhaust header |
YAY wicked! i got it from the underneath side of the engine thing and stuff i am so happy right now, except i dropped the header on my finger and it hurts. cheers for your help everyone this has been more than a mediocre afternoon full of average events. Awesome!
|
All times are GMT -5. The time now is 10:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands