Rotary Fiat
#1
Full Member
Thread Starter
Join Date: Jul 2009
Location: louisville ky
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Rotary Fiat
Hi everybody im Austin from Louisville Kentucky. I am building a Fiat 124 spider race car with a NA 12a peripheral port im looking to be revving at 10000-10500rpm peak. I am about to order lightweight rotors,carbon 3mm apex seals,hardened stationary gears, and a RB holley intake manifold With Holley carb. I am also making a portmatched header and custom 3 inch exhaust. I am hoping to get at least 250hp out of the motor. Do you think its possible? And what ignition upgrades would i have to do?
#2
1200 gone......but......
iTrader: (24)
Join Date: Oct 2006
Location: so cal
Posts: 902
Likes: 0
Received 0 Likes
on
0 Posts
I wasn't aware that Racing Beat sold a Holley intake manifold for a peripheral ported engine. They do have the intake for a downdraft Weber setup. Must be something new........
#3
Full Member
Thread Starter
Join Date: Jul 2009
Location: louisville ky
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
no im sorry i ment that i that im building a custom manifold off of that because the carb should flow enough it was a good starting point but ive been wrong before i might have to step up to an even bigger carb
Thread
Thread Starter
Forum
Replies
Last Post
datfast1
Old School and Other Rotary
18
06-20-19 10:53 PM
Under PSI
3rd Generation Specific (1993-2002)
19
09-23-15 11:47 PM