Wiring up a 20B to Haltech PS2000
 

Anyone here can share some insight here. And what they used to make the loom look OEM.

Really its just about the same as a 13b except more inj an coil pack, most just make their fuse/relay box up at the firewall where the harness comes in and mount your 3bar up there as well and then i like to wrap the harness in e-tape an those plastic covers around it an run it along the firewall an come in behind the intake manny for a nice wiretuck. As for coil packs i would mount the new right up near the trailing pack (if on fc) an that should about give you a nice cleen look

THIS is a great place to start. Haltech Forum - RX7Club.com

Thanks Ozurdin and Misterstyx69. Will work on it when get back from my Vacation.

Thanks once again......

Awesome, post some pics when you get it setup!

Wiring Loom Cover
 

I am currently in Frisco Texas on vacation, and wanted to know if there is a good place to get wire loom wraps ( Wire Cover or Sleeves), Wanted to make my Haltech wiring loom to look like OEM.