Weber carb tune? and clean.
Hello names Denton. I have a 83 rx7 gsl. The 12a is stock, only thing it has is a webber 48ida carb. I took the carb off to clean and check venturies, choke size, jets ..etc . The car idle s and runs Okey. But you have to slowly hit the gas for it to run good. If you slam the throttle it bogs bad. Can y'all tell me what the issue is and what I need to get? It has. 45mm choke. Isn't that hugs for a stoke 12a? Has 37 mm ventries.
Needle 200 Main jets- air 120 Main-135 Small jets. /idle Top jets -120 Bottom- 70 f10 Sorry idk to much about carbs. But if any one can help that'll be awesome! I also have the stock headers for exhaust. Thanks! -denton |
What size are the chokes should be 40mm ,Your aid correctors are ok at 120. Main jets should be around 190. emulsion tubes F 2 . needle and seat a 3mm
|
Originally Posted by WJM ROTARIES
(Post 12025719)
What size are the chokes should be 40mm ,Your aid correctors are ok at 120. Main jets should be around 190. emulsion tubes F 2 . needle and seat a 3mm
|
Originally Posted by r0to-D3wd
(Post 12025737)
The choke s said 45 on them there pretty thin. So my main jets should be 190? And the tube f2 not f10? The needle and seat said 200 does that mean 3mm?
|
200 is 2mm you need 3mm the choke marked 37mm needs to be 40mm
|
Originally Posted by WJM ROTARIES
(Post 12026570)
200 is 2mm you need 3mm the choke marked 37mm needs to be 40mm
|
No that one is fine and will work ok
|
Originally Posted by WJM ROTARIES
(Post 12026748)
No that one is fine and will work ok
|
Emulsion tubes F2 works the best
|
okay! thank you for all the help man
|
No problem . Glad to help
|
All times are GMT -5. The time now is 06:55 AM. |
© 2024 MH Sub I, LLC dba Internet Brands