Trouble with Dale Clakes speedo hack
Thread Starter
Junior Member
Joined: Oct 2012
Posts: 15
Likes: 2
From: UK
Trouble with Dale Clakes speedo hack
https://www.rx7club.com/3rd-generati...o-mph-1015964/
I tried this on a JDM 98 car to get it's 180kph guage into mph. The Odo mileage has changed into miles from Km. However the Speedo is still Kph.
I also caused a lot of damage to the SMD resistors pads and replaced with a through-hole of the same value. (my 98 cars glue was strong)
Perhaps JDM cars are slightly different. I should probably try soldering the resister to the lower left position a bit scared of f****** the big IC though due to that boards cost of replacement.
Interestingly with my borked cluster the trip computer records every KM as a mile. So my mileage is going up 1.6x faster than it should.
Any advice on a solution, anyone?
I tried this on a JDM 98 car to get it's 180kph guage into mph. The Odo mileage has changed into miles from Km. However the Speedo is still Kph.
I also caused a lot of damage to the SMD resistors pads and replaced with a through-hole of the same value. (my 98 cars glue was strong)
Perhaps JDM cars are slightly different. I should probably try soldering the resister to the lower left position a bit scared of f****** the big IC though due to that boards cost of replacement.
Interestingly with my borked cluster the trip computer records every KM as a mile. So my mileage is going up 1.6x faster than it should.
Any advice on a solution, anyone?
Last edited by misterstyx69; Mar 16, 2013 at 12:13 AM. Reason: no need for sarcasm..deleted.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
Oct 3, 2015 01:08 AM
