RX7 Steering Column (shaft) Movement
This is a low-mileage '84 and some time ago I noticed that if you put both hands on wheel, and gently but firmly pull upward, the wheel pulls up about 3/4" (not measured). At the same time, this movement rides over the cancelling part of the signals - until wheel is pushed down again. Don't know what caused this and I suspect it has something to do with shaft? I know (the shaft) is solid into the gearbox but how is it secured? Yes, likely a dumb question but I need to be 'steered' into the right direction - before removing related parts - for first time. Thanks. :dunno:
|
Pretty sure it has something to do with a bushing that is in the column itself.
There should be some info in 1st Gen Specific on that. |
welcome to the board. :)
2 out of my 4 FBs did that. it's an annoyance. however, while disheartening when it first happens to you, it's actually designed to do that ... in the event of a crash. you can leave it or you can fix it. https://www.rx7club.com/1st-generati...uestion-76672/ |
Thank-you for info and Link, guys. I did reply to that (old) link - in hopes of update.
:scratch: |
All times are GMT -5. The time now is 07:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands