Need help with my wire harness/temp gauge!!!
 

Ahhhh! This car is driving me nuts!!! So I swapped the motor on my s4 fc to a 13b-re n none of my gauges were working due to I had to swap the sensors out so my harness can plug up I got the tach,and oil pressure gauge working so far but now I can't find my water temp plug anywhere on my harness!!! Can someone tell me where on the harness it's located??? I looked in my Haynes manual and read that it's a yellow/white wire n should have a bullet style connector but I do not see it I can't find it its really aggravating so I'm thinking maybe it was ripped out ir broken off during the swap so can someone tell me how to backtrack this wire

Ok I can kinda get some help from that but maybe u further help my prob Cuz I'm still a little confused being as wiring just isn't my cup of tea.... So mine is a 87 turbo car with the turbo wiring harness and I been going crazy looking for the y/b water temp sender plug but for some reason it is non exsisting where it should be Im thinking it might of been snipped while my microtech was being installed maybe so what I wanna do if find it on the begging of the wire harness connector (x-15) and just rerun the wire to the sensor n be done with it but what my issue is where on the car would that harness conector located exactly???

I meant y/w wire

On a turbo set up the Y/W wire of the emission harness (found between the Black wire and Green/Black wire) connects to a Y/B wire at connector FEM-01 while on a non turbo harness the wires mate in connector FEM-02 where the wire on the emission side lies at the very end of the plug next to a B/W wire.

Thanx bud I guess I had some sort of connection issue too I had to go directly the dash splice the y/w n rerun a wire all the way to the sensor