RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   New Member RX-7 Technical (https://www.rx7club.com/new-member-rx-7-technical-256/)
-   -   Need Help Bad!!!!!! (https://www.rx7club.com/new-member-rx-7-technical-256/need-help-bad-785824/)

FD Brian 09-09-08 10:21 PM

Need Help Bad!!!!!!
 
Ok so i just bought a fd shell and put a jdm 13b in it, there are some wires that i dont know where they go and i need help from you guys, On the body harness there are three wires located by the oil pressure sending unit the first one is Black with red strip, the second is brown with blue strip, the third is yellow with red strip.
On the engine harness there is a yellow wire with a white or silver strip and is located right before the engine harness enters the engine. The last thing is the blue connector that connects to the piece inside the car from the engine harness, both pieces are different sizes and dont fit < what the hell are these wires and what do they do, i live in a condominium and its against the rules to work on my car in the garage so i need it done by tomarow, the car wont start so are these any reason for the car not starting? i also have done a non-sequential conversion done but didnt put resistors in the rats nest wires so will that not make the car start?

Please Help:wallbash:

FD Brian 09-11-08 10:45 PM

^^anybody^^

Rx7_Nut13B 09-12-08 01:42 AM

Black with red strip - Goes to the selinode on the start, it tells the starter to run.

brown with blue strip - ?????

yellow with red strip - Looks like one of the speedometer wires, the other is yellow/white (attaches to rear of Trans)

yellow wire with a white or silver strip - Could be the other side of the speedometer wire. (attaches to rear of Trans)

blue connector Problem - Well are you using the harness that came on the JDM motor, if you are there is a possibility it was a Auto. Well the Blue plug is different between the 5 Speeds and Auto. Also if yours is a Auto and the JDM motor is a 5 speed it will not work. You will have to use the stock harness on the motor, or search on the forum for Auto to 5speed swap and there is a wiring diagram to show you how to mod it to work.


For some of the above I was not 100% sure witch one you where talking about, this is the wiring diagram for a 93 FD, but the 94 and 95
are pretty much the same.
http://www.wankel.net/~krwright/file...ng_Diagram.pdf


All times are GMT -5. The time now is 12:04 AM.


© 2024 MH Sub I, LLC dba Internet Brands