motor mounts gone bad?
hey guys denton here, i know iv already posted about how my car will vibrate the shifter nob at about 3k rpm and up. yall helped me out quiet a bit but i have another question. iv been reading and a lot of people say rx-7 motor mounts are just solid mounts so theyll shake your car some cause there coping with the engine power. is that true? and also what about a warped fan? coukld that be the issue? if yall could maybe help tell me how to check a few things so i can see if there the problem id appreciate it, i just need to narrow it down to find the issue. once again my throw out bearing is spining a little bit. not bad, but i can here it rubbin. THANKS ! -denton
|
What year? Sounds like U-Joints to me.
|
Originally Posted by Fuhnortoner
(Post 12027927)
What year? Sounds like U-Joints to me.
|
I would check into getting shifter bushings, if they are worn the shifter will vibrate a lot
|
Originally Posted by evo_koa
(Post 12027954)
I would check into getting shifter bushings, if they are worn the shifter will vibrate a lot
|
Originally Posted by evo_koa
(Post 12027954)
I would check into getting shifter bushings, if they are worn the shifter will vibrate a lot
|
Very good possibility
|
Originally Posted by lduley
(Post 12028272)
Very good possibility
|
That mount is suppose to be a solid piece. It's cheap.
|
Originally Posted by KansasCityREPU
(Post 12028688)
That mount is suppose to be a solid piece. It's cheap.
|
it COULD be your vibration, you or us won't know until you replace it. It obviously needs to be replaced anyways because like REPU said, its supposed to be one piece, and it sounds like it isn't from your description
|
Originally Posted by lduley
(Post 12028779)
it COULD be your vibration, you or us won't know until you replace it. It obviously needs to be replaced anyways because like REPU said, its supposed to be one piece, and it sounds like it isn't from your description
|
Originally Posted by r0to-D3wd
(Post 12027941)
its an 83. 12a stock. all it has is a webber 48ida carb on her. and people have told me u-joints but would they make the vibrating noise when the cars in neutral? it does it in neutral, when the clutch is pressed, and when the clutch is depressed. when im driving and in gear and press in the clutch it stops when the rpm goes down. but if im driving and down shift and let off clutch it vibrates till the rpm get below like 2800rpm.. thanks for the reply btw!
If the mount was good then the mount would absorb the difference in speed and you would not get the shake. |
All times are GMT -5. The time now is 08:11 AM. |
© 2024 MH Sub I, LLC dba Internet Brands