ignition identification?
 

I have searched the forums for bout two hours now, (the amount of info is exausting - i might just suck at searching) and did not find the answer I am looking for, the question is this: does my wiring at my ignition switch have to be soldered when i replace it?

This is where I am at:
1. from what I have read about a recent problem- hazards and wipers went out, probably the ignition switch--
2. then today, nothing happens when I turn the key, and I just put in a new battery last month! - okay, probably the ignition switch finally went completely out...
3. I removed the horn and plastic housing from the steering column and discovered soldered wires(i have never messed with this before) and I dont know how to remove or repair them.

Any help with further diagnosis or tips would be helpful, seeing as how I am flat broke and am doomed to repair this myself...:dunno:

hya by the time you get that thing up and running he will have prolly have another probllem. a pc with 98 will take 6 days to turn on

x2

my car is: 85 with 12a and Nikki. all stock, except inards of the carb- carb was rebuilt by rotary performance in Garland, TX- the recommended upgrading the seats with a bearing type(or something like that)
Everything else should be stockas far as I know-- and btw: I'm hoping you can verify my suspect diagnosis that an ignition switch could also be the culprit for my windshield wipers being stuck and not working, and hazards not working at all-- for this problem I have already checked all the dash fuses, and none are blown.
in another thread someone IDed it as a possible cause...
thanks again--

If they aren't used on a regular basis, the wiper rack tends to rust and freeze up beyond fixing status....try to work the rack by hand or run your battery volts, via jumper wires, directly into the harness clip of the rack to see if it's still good. Let me hook up the W98 tonight...I wrote a postie to myself so I'll be sure to remember...:crackup:


:cool:

Here's the only two pics I could find...the car wouldn't start consistently, sometimes the accessories would all not work, no blower fan, no radio, etc....I worked the solder points seen here, but it turned out to be the actual plastic cap all that stuff sits on. I used the purple zip tie to re-establish the correct contact force on that ignition switch and that cured the problems.

https://www.rx7club.com/attachment.p...1&d=1242358925

https://www.rx7club.com/attachment.p...1&d=1242358925

...and no, I don't remember what all the arrows were for anymore...those pics were part of an old tech thread I did way in the past...I'd have to dig that thread back up to get the answers... ;)


:cool:

i have a compaq running 98. it's actually alittle faster surfing the net than an hp i have running xp. i figure it the network card tho.

yes it seems to want to work now!!! thanks for all the help-- I've got hazards, but now, because it rained and wipers werent working, they rusted in the up position!! lol

I'll be cleaning those up soon-0-0

Thank You again for taking the time to advise me!

Jody