RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   New Member RX-7 Technical (https://www.rx7club.com/new-member-rx-7-technical-256/)
-   -   Hybrid 13B Motor Need Help (https://www.rx7club.com/new-member-rx-7-technical-256/hybrid-13b-motor-need-help-1057607/)

Brync21 02-19-14 11:13 AM

Hybrid 13B Motor Need Help
 
My names Bryant I have an 83 rx7 has Front/ Intermediate/Rear Housing are from a 84-85 GSL-SE. Rotor Housings are from a 88-89 Turbo ii for Better exhaust flow with no baffle plates is this common? I bought the Car a week ago and I have Put some money into it and want to know if I should stop It has a dellorto carb and right under the Carb there were two dimes capping some holes in the motor, but I dont know what goes there? is that for emissions? when i stuck a rag in there to cap it car idles and runs fast but if it comes loose it starts to misfire and shake pretty bad any suggestions on what the two holes could be and if the engine set up is common? Im just learning to work on the car to get it running correctly before I learn how to add any mods to it.

Greatly appreciate the feed back.

snivley whiplash 02-19-14 07:46 PM

Bry,
where the dimes are is the laocation holes for the secondary fuel injectors for the -se engine. so now being carbed you need to plug the holes correctly so you do not have an air leak. mine are made from two pieces of round stock aluminum made from racing beat usa. purchase them and install and all should be well.

Joe

diabolical1 02-20-14 09:31 AM

welcome to the board. :)

i guess i should encourage you to do it right, which would be to buy or fabricate so injector block-offs. however, having never bought "proper" block-off nozzles, and having used dimes myself, you need to seal them with silicone. :) i ran like that for about 6 years. no issues. no vacuum leaks. you need to eliminate all vacuum leaks before you start tuning the Dell.

those holes are actually for the PRIMARY injectors - and if the engine is really an S3 (SE) engine, then it's just "the injectors" because the SE only had 2.

out of sheer curiosity, are you sure the engine was hybridized as you said? also, '88 and '89 span two Series' of engines.

Brync21 02-24-14 11:51 AM

Thanks for the help. I might just swap out that dellorto carb because I also have 230 Jets on there and its running pretty rich. Im in the process of purchasing 510 gears for it i have beefed up the interior I just dont know where to post pics on here ahahah i suck at threads.

Brync21 02-24-14 11:55 AM

Yeah the guy i bought it from that rebuilt the motor gave me that setup the engine runs super strong only have 3000 miles on the rebuild and less that a 1000 on the tranny the the spec stage 2 racing clutch.


All times are GMT -5. The time now is 05:28 PM.


© 2024 MH Sub I, LLC dba Internet Brands