a few 87 rx7 issues...NEED ANSWERS!!
 

my 87 rx-7 non turbo 1.3 13b runs n drives perfectly...but i have a few litlle concerns...1st is when i accelerate at 4,000-4,500 rpms it hesitates just in that tiny gap of rpms...why is that and 2nd my add coolant light keeps goin on and off...but ive checked all my fluids, and car does not run hot...it runs no more then half and temp...why is this?? bad sensor?? and is their anyway i can stiop the damn buzzing noise?? ITS ANNOYING...this is a dumb question but where the hell is the fuse panel....?? i dont have and owners manual and cant find it... and last for now...is my heater control unit sometimes does not switch to a different area and the heat will be really hott then it will go cold for a few seconds...once in awhile and my rear defrost dont work....all these questions would greatly be appreciated for answers thanx guys!!

Check the 2nd gen FAQ for "3800 RPM hesitation". https://www.rx7club.com/showthread.p...55#post5131155

The wire to the coolant level sensor may be damaged or loose, or the connection may be corroded. You can also have air bubbles in the system, which should be bled out using the plastic screw on the top/side of the radiator. Remove the radiator cap and loosen the screw slightly. Coolant will drip out, so place a rag underneath. The coolant level should drop and some bubbles may escape. Add coolant until full, tighten the screw and replace the cap.

Fuse panel (FAQ): https://www.rx7club.com/showthread.p...72#post5131072

FSM links (FAQ): https://www.rx7club.com/showthread.p...18#post5131218

The logicon may have cold solder joints which cause intermittent problems. The rear defrost switch may have the same issue, or you could just be seeing it switch off after ~15 minutes (normal).

thanks roatry rocket..ill check that tomorrow and let you know what the turn out is...this is my first rotary so...gonna be askin alot of advice..!!