FC bounce idle
11-21-17, 05:09 PM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Nov 2017
Location: Kentucky
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
FC bounce idle
I have an 88 FC Rx7, I'm still fairly new to rotary engines. I do have basic knowledge of them. When my FC warms up to operating temp. it seems to bounce idle or rev slightly. I can rev and drive the car just fine.
11-22-17, 06:57 AM
#2
I bounced at idle as well with a t2 I just got. I found a vacuum hose leak and my turbo inlet duct had a crack, which is basically more leak. After I took care of those, my idle was much smoother.
02-17-18, 11:31 PM
#4
Just to clarify, what is a bounce at idle? Once warm my car goes from around 800rpm to 750rpm, it just kind of dips down by 50rpm for a second then goes back up.
The car pulls to redline in gear just fine like the op. If I check all my vacuum lines I should expect to find a leak? Is there a good trick to finding very small leaks such as spraying with soapy water or is that bad for the rubber hoses?
The car pulls to redline in gear just fine like the op. If I check all my vacuum lines I should expect to find a leak? Is there a good trick to finding very small leaks such as spraying with soapy water or is that bad for the rubber hoses?