Bosch Ignition Spark Plug Wires Order
 

Hello from Borneo. Am fairly new to the world of rotary so this question might have been asked before but I have searched and still could not get an affirmative answer.

I've replaced spark plugs numerous times on my car and I have always done it one plug/wire at a time so I never had an issue with the wire till yesterday. I had a friend over yesterday and while chatting and swapping out the plugs, I accidentally remove 3 wires altogether. The only one that is left on is T1 (which was previously labelled by the old mech as "1" as you can see from the pics) and Wire 1&3 are short wires whereas Wire 2&4 are longer wires - not sure if this helps.

Now I have no idea which wire goes to which plug. I know which is L1, T1, L2, T2 but I dont know which wire from the coil goes to which plug. I'm hoping you guys can help.

I'm running Microtech MTX-12, Bosch ignition and FEED wires on a FD3S.

Again I apologize if this question has been asked before and TIA for all the responses.
https://cimg5.ibsrv.net/gimg/www.rx7...145e32cda0.jpg
https://cimg7.ibsrv.net/gimg/www.rx7...fe8a453ac2.jpg