4 barrell carb jetting question ?
he guys i have a 69 510 datsun that i did a motor swap to it. took out the old motor and put a rotary 13b. since i like the way the rotary sound and run there fast little motor , since i have a 83 rx7 with a 12a, and it runs like a champ. well back to the 13b everything is done already. i put a kit from racing beat that has a holley 600 cfm 4 barrel carb that is a direct bolt on kit. but the car runs roughs. 1st and the 2nd gear it backfires alot. the car has a 13b witch is stock with a litter flywheel from racing beat the 4 carb kit from R B ,and full R B full header racing exaust. can u please help me , and im wondering if that also the reason im getting alout of fumes inside the car ? lol.
|
what yr is this 13b? if it's a late model that ran a cas and u swapped in a dist, make sure the timing is right, plug wires going to the right plugs, etc. outside of some fine tuning, those carbs should run fine right out of the box.
|
Originally Posted by rxtasy3
(Post 9442555)
what yr is this 13b? if it's a late model that ran a cas and u swapped in a dist, make sure the timing is right, plug wires going to the right plugs, etc. outside of some fine tuning, those carbs should run fine right out of the box.
|
sometimes during shipping, the carb is flipped around and shook around, sometimes the needle and seat stick or a check valve sticks, you can take the butt end of a screw driver and light but firm, tap the tops of the bowls to free them up. Also, verify your float level is correct and fuel pressure correct.
|
Originally Posted by buldozr
(Post 9442919)
sometimes during shipping, the carb is flipped around and shook around, sometimes the needle and seat stick or a check valve sticks, you can take the butt end of a screw driver and light but firm, tap the tops of the bowls to free them up. Also, verify your float level is correct and fuel pressure correct.
|
any updates?
|
Originally Posted by buldozr
(Post 9451125)
any updates?
|
Originally Posted by buldozr
(Post 9451125)
any updates?
|
well a 3rd gen 4 port with a holley that is tuned would make more power than a 6 port.
|
All times are GMT -5. The time now is 10:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands