2001 RX7 FD - Limp Mode Issue! Help needed
Hi All!
I have recently imported a 2001 Rx7 FD3s RZ into Australia last week and had the car go into limp mode on the 2nd day. I have followed some of the instructions that other members have suggested in the other threads. Oil & oil filter change, reset ECU by removing battery for 15minutes. Plug it back in and the car was running again and a lot smoother than when I first got the vehicle. The engine was running well and had no issues for the next 6 days. On the 7th day since the previous issue, this morning the vehicle has gone into limp mode again, went for a drive last night but did not do anything out of the norm and did not push the car to the limit either. Just a relaxing cruise to enjoy the car. My car is back on Limp mode and this time even trying the ECU reset this morning did not work. Spoke to a mechanic and he thinks it is a bit strange, initially he mentioned it could be a faulty solenoid. However being able to drive the vehicle for 6 days without any issues he is doubtful that it is the solenoid. Will be bringing the vehicle into the workshop on Thursday and was hoping I could figure something out before then. I was hoping someone might be able to shed some light on this issue :( |
The last FD to be legally imported to North America was in 1995 and an OBD 1 system. Not sure about your car. You'll have to pull the codes to find out what's causing limp. Limp is designed to protect the engine in the event of a failure with something MAZDA considered critical. It pulls timing and fuel if vacuum isn't seen by the MAP sensor. fdrx7.com may have some locals to you with better insight.
|
Potentially damaged wiring? I had a very similar issue that occurred sporadically, turned out to be a bit of solder that had come off causing only intermittent dislodging.
It did cost me £340 in fault-finding fees to find a 5p bit of solder though... :( |
Again, not familiar with the later cars, but it didn't cost anything to pull CEL codes on the OBD 1
Check Engine Light Codes |
Hi All!
Thank you for the feed back :) The check engine light does not come on. However what the car is doing was diagnosed as Limp mode, I hope this makes sense. (No power over 3k RPM, and if you try to step on the accelerator a little bit more the power drops off and feels like the vehicle is about to stall) I will be bringing the car into the mechanics workshop on Thursday and hopefully it is nothing major. Will keep everyone posted. |
All times are GMT -5. The time now is 01:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands