Help needed to new 12A NA project
Hi
I need some advise for my new rebuild. The rx7 1982 is a street car (not a daily driver) that do some times trackdays and gymkhana. I want port the 12a engine, and want the best power i can get from it, i would like 150/160rwhp, but my redline is 8500rpm and i ideally want top power at 8000rpm. I have a weber 48 ida, RB RB road race header, RB power pulse main muffler, and a custom mid dual pipe. What the size port combination that you recommend me? race streetport intake and race exhaust port? Race streetport intake with a smaller exhaust port? Another options are well received. Regards |
well depending on the health of the engine and the tuning, you actually should be in the 140-150 rwhp range already.
so if you still want to port, i'd do a street port. that should have you in the 160-170whp range give or take of course depending on the dyno you're using |
If you want a fast motor bridge it ,you have the right carb and header for it . and I think the last posters rwhp numbers were a little to generous . my old street port 13b fully tuned with the proper exhaust and carb produced 166 rwhp at 7800 rpm so logically the 12a with a street port would be a bit lower .
|
Originally Posted by mattallac
(Post 11420653)
and I think the last posters rwhp numbers were a little to generous
a stock 12A with the pro7 setup, stock carb, stock exhaust, will do 110-112rwhp. add an RB header and you're in the 120-125rwhp ballpark, but after that its a bit hazy. a bridge should be around 180-210, bridges vary in size! and the P port should be like 225rwhp |
I will do a large streetport and machting exhaust port from Pineapple Racing. Hope achieve 160rwhp!
Regards |
All times are GMT -5. The time now is 08:22 AM. |
© 2024 MH Sub I, LLC dba Internet Brands