Tps
 

I have an LT8 and I know the s4 tps has been an issue with it for a while now, I was wondering if moving to a s5 tps would help the all or nothing i get from the s4 tps with the lt8

Quick and cheap fix.
 

Hi Fuzzy

I am new to th eMicrotech system but from my resent reading I think you can replace with any TPS. Then just go in and set it up. I mention this because the Mazda TPS are big bucks. I made use of a TPS that I picked out of a catalog at my local auto parts store ($24.85) one drilled hole in the lever and a bent stainless steel wire bingo trouble free TPS. This TPS was used with a different engine management system with no problems. I assume the same with the MT/LT units.
:icon_tup:

Yeah, im not really worried about cost its mainly that i have a s5 tb w/ tps but dont want to swap it if it doesnt make a difference.

it won't make any difference It only read all Or nothing.

so its on Idle or off

why do you think your tps is a problem?

I though the TPS was the problem because the s4 tps after 20% throttle it goes to WOT. I know that they addressed this issue with the s5 by adding a second sensor. I also have a FD tps which is a totally different style and was thinking about trying that one also. It might not be my TPS it might just be microtech ingeneral my friend has a PowerFC and has a full range of throttle.

how are you guys going into the microtech and changing the sensor type. i was under the impression that you could change the sensors. i had a iat go out and wanted to change it to a gm style one and was told that, that would not work b/c you could change the values for a given resistence.

your tps isnt your problem.

still curious on changing the sensors input resistance's?

You can run any TPS you want. The Microtech just looks at a 0-5V signal. I run a Ford full range TPS as I use an aftermarket Mustang throttle body.

By default the acell pumps are MAP referenced. With large porting this can be problematic so switching to TPS referenced is sometimes necessary. In which case you will want a full range TPS. Otherwise the TPS is just used for idle/off idle and flood clear. You can use a switch if you want.

right, i know you can switch tps's but what about changing the iat?

You can't change the IAT from what is programmed into the Microtech if you still intend it to read the correct temperature.

Hey
 

I Have An S4 Tps That I Am Wiring To My Lt10 But I Dont Know What The Hell The Blue Wire Goes To The Instructions Say It Has 2 Grounds But They Say White To Yellow Which I Got But Then They Want White/black To Blue But I Got Blue To Light Blue? Please Help

Um, what?

English, please. :)

the blue wires goes to the orange wire on a s4 tps. the grey wire goes to the green wire on the tps. the brown wire goes to the black wire on the tps.


i hope that helps.

thanks for the help sry to jack the thread.

you could use the FD iat just need the plug with it, is the FD tps full range?

Yes it is.
But i dont know how many times i need to say it.


Microtech+full range tps= complete waste of time.

It's not a waste of time if you need to run Alpha-N. Also it's handy when datalogging. :)

TPS based acell enrichment is also far superior to MAP based in many cases (ie. bridgeport).

i agree in the case of a bridgeport, anything that pulls poor vaccum, then yes it is excellent to have.
but it seems the person above is doing it for the wrong reasons.