Single turbo base/break-in Map NEEDED
 

I need a Base Map for my Microtech LT-10 for Break-in on the new motor.... Where can I get one for cheap/free?

Here are the Engine and Fuel Mods

1994 Mazda RX7

ENGINE
Full Japtrix rebuild and street port w/ 0 miles
Xssessive LIM port matched
Pettit lower pulley
Greddy water pump & alt pulleys
Block off plate kit
Solid aluminum motor mounts
SS manifold
SS 4" dp
Custom Midpipe
Greddy PE catback
Custom turbo: T63 w/HKS T67 comp wheel, .84 a/r exhaust w/3" v-band
Twin oil coolers with -10AN lines and fittings
Greddy 3-Row FMIC
Koyo Radiator
7 Blade JDM fans
TiAL BOV
TiAL 44mm Wastegate

FUEL & ENGINE MANAGMENT
Walbro intank pump
Speedmachine Surge tank
Aeromotive A1000 pump
Aeromotive 100micron filter
Aeromotive 10micron filter
-10AN fuel line and fittings to a "Y"
-8AN fuel line and fittings to fuel rails.
KGParts fuel rails and injector sleeves
1680cc injectors x 4
Aeromotive FPR
-8AN return
MicroTech LT-10s
LTS 4 Hand held programer
MicroTech ignition amp
Bosch coils x 4
Apexi AVC-R boost contoller

Thanks :)

for anyone that is willing to make me one... I will be sure to hook them up if they want money for their time.

Best Regards,
Alex

Perhaps one of the maps in this thread fits your car: https://www.rx7club.com/microtech-111/tii-stock-base-maps-343297/

Good luck

thanks.... post 26 looks like a place to start but he is running half the injector i am....