Microtech Runtime error 13!"#¤&"
#1
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Norway
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Runtime error 13!"#¤&"
Well as the topic says I get runtime error 13 when I try connecting to the microtech... lt10s with x4 if that matters..
I have the dongle connected, usb adapter and all that, and this was working before i formated the computer...
Im using the software from the CD that I got with the dongle, and I've tried the software on the official site.
Also I can't change the com port settings for some reason in the Device Manager?!
Both com3 and com4 get the "runtime error 13" (com 3 and 4 is the com is sets to when I plug it in the USB)
Any help?
https://www.rx7club.com/attachment.p...d=224659&stc=1
I have the dongle connected, usb adapter and all that, and this was working before i formated the computer...
Im using the software from the CD that I got with the dongle, and I've tried the software on the official site.
Also I can't change the com port settings for some reason in the Device Manager?!
Both com3 and com4 get the "runtime error 13" (com 3 and 4 is the com is sets to when I plug it in the USB)
Any help?
https://www.rx7club.com/attachment.p...d=224659&stc=1
#2
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Norway
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Im trying this now:
will get back to you with result...
Originally Posted by projectredsuns
Ok this is info needs to be stickied. But I will say it again. If you use a 9-pin usb adapter. You need to uninstall microtech, uninstall all your 9pin-usb drivers/software. And start fresh. Install the usb adapter configure it to port 1. Restart the machine. Reinstall microtech and it should work just fine.
#4
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Norway
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by teachermechanic
microtech
Hi, just change you computer language.
Pass one year i had same problem.
Hi, just change you computer language.
Pass one year i had same problem.
I changed all my regional and time settings to United States, and it worked...
Thanks for the help teachermechanic!
Vegard
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
0
09-16-15 01:25 PM