Ref Error?
I have an Ref error, but am not sure what that is, does anybody know?
I was very carefull not to save anything or change anything to memcal 1, which I assumed was the base map. In fact the only thing I changed I saved in memcal 3. When I load any setup and look at the setting's everything is set to zero, timing, fuel, everthing. Even when I revert to the base setup everything is zero. Does this have anything to do with with the Ref error? I also have a TEST ON display on the Dash unit, does this have anything to do with the problems? I'm kind of stumped to say the least. Any help would be greatly appreciated. Cheers Graham |
if you have test on you have the ecu set to test mode, to fix this you need to change the amount of cylinders on the config screen to 4, yours will be set to 0,
ref error means there is a problem getting sygnal from the CAS on the referance pickup (the larger bottom one) mine gets this if the engine goes to stall and i catch it just before it stops. Dale |
Originally posted by 10sec rx7 if you have test on you have the ecu set to test mode, to fix this you need to change the amount of cylinders on the config screen to 4, yours will be set to 0, ref error means there is a problem getting sygnal from the CAS on the referance pickup (the larger bottom one) mine gets this if the engine goes to stall and i catch it just before it stops. Dale I got it out of test mode, and fixed the rpm and ref error. |
All times are GMT -5. The time now is 09:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands