Msd Coils Not Shooting?? Please Help
Hi i have a microtech lt10s with x4 box..... i have the coils wired the correct way because about a week ago when the car was still not completed we started the engine. but for reasons unkown to me the coils are getting power to the positive side of the coils and the negative side. i know its not the wiring because i have power only running to the positives on the coils. and the negatives are connected to the X4 box..
please someone help me i really cant figure this out! thank you, Vic |
its normal that power travels accross the pole.
what your actually looking for is that the negative flashes when your cranking. if it dosnt flash your x4 box is dead. |
ok.. the Microtech itself shows the orange light flashing (the ignition pulse light).. so i would have to send it in to microtech then... and how can that happen if i havent done anything to it.. it jus sat in the car i haven driven the car or nothing
|
orange light is a pulse from crank angle sensor.
if that is flashing then that is good. So your saying that when you put a test light at the coil packs it isnt flashing? |
no sir the test light wont flash to negative?? i just has steady power to both sides... do you think theres something wrong with the microtech??
|
Have you grounded the earth wire that goes to the x4 box, to the block.
Why did you use MSD coils and not the bosch coils? Microtech dont recommend any of the MSD gear. Recommend bosch. If your earth wire from the x4 box is grounded and still no spark. The x4 box/microtech need to be sent back. |
i have the x4 grounded but not to the block? its on the firwall...
how can i go about sending the x4 box/microtech back??? the MSD's were recommended from a shop where im from, but when i first finished the setup the MSD's worked very well. |
Next time dont use them. I have never had anything but trouble from MSD.
AND your ground should be on your BLOCK. This is what has killed your X4. Youll have to send the microtech back to a dealer here in sydney. And they will have it dropped off at Microtech Putney to be repaired. or you can send it to John at www.microtechefi.com |
you should move to the U.S.A we need more techs like you over here
|
All times are GMT -5. The time now is 02:37 PM. |
© 2024 MH Sub I, LLC dba Internet Brands