Microtech lt10s starting issue
 

I have an S5 TII with 750cc secondaries, stock turbo, arc top mount and I have a microtech lt10s with the x4 ignition, my car gets right to where its about to start, but then just keps turning over. I currently have silverrotor's TII map in my car and I feel like im at a dead end, any ideas?

Upload some snap shots off your program. Have you recently rebuild or done a compression test?

idk how to uplad photos, and compression is good according to pettit racing

it was rebuilt before I got it**

Was the car running before with the program from silverrotor you said that you upgraded your secondaries but still should not cause it to not start. Make sure your map sensor is fitted correctly then check your calibration on your Tps if all is good pull your plug s out lmk what you see...

I tried to calibrate the tps and I couldnt figure it out at all, I have to be explained to like a 5year old when it comes to electronics. hahaha

I removed the leading and trailing plugs on the rear rotor and the leading was dry but the trailing was wet

^^ same goes for the front rotor as well

map sensor fitted correctly you mean the vacuume line going fromt the intake manifold to the microtech?

OK vacumn line is fitted so check. Trailing plugs wet so you definatelly getting fuel as leading that works as a wastespark so that's ok. Now for the tps that needs to be calibrated for the car to start on smoothly. So I'm going to pm your number and just text me and ill tell you exactly how to calibrate but you need a hand controller or laptop with a single.

I mean dongle

alright sweet, thanks a lot! when we speak on the phone, there are a few updates on the car I want to make you aware of as well.

ok well idk what the hell I did, but it runs and starts just fine, its hard to get started but it starts, the real text will be tomorrow when the engine cools down.