microtech and injector dynamics
i have a LTx-12 and i am trying to run ID1000`s on primaries and ID2000`s on secondaries
is there some special setting that needs to be input in the settings , i just cant get it to idle or work , seems to run LEAN if anything before the swap i ran Rc engineering 1000 primaries and 1600 (generic brand) secondaries , it ran fine and idled ok i will mail microtech directly later but i`m just wondering if any of you guys have bumped into this already |
Figured out the problem , it was a combination of ,low battery voltage and me removing the atomizer , all seems fine now
|
Originally Posted by felix_is_alive
(Post 11799788)
Figured out the problem , it was a combination of ,low battery voltage and me removing the atomizer , all seems fine now
How did you fix the issue? |
i had them in , the main issue i had was my previous setup , the injectors were not the appropriate type , so i kept the atomizer since they have a bunch of o-rings around them to help seal the manifold .
but with the FFE kit the Injector Dynamics came with this nifty adapter that i could remove the atomizer and have a good seal so in short the atomizer i believe changed the spray pattern of the previous injector (RC engineering) plus a the fact that i had low battery must have screwed with my settings , or most likely kept my fuel press a bit low . charged up the battery and played a bit with the tuning and everything is golden maybe the atomizer required me to use slightly more fuel ? not sure but it works at first i was worried that the microtech could not handle the six ID injectors , but Jon from microtech assured me that it was no problem , and its handling them like a pro |
Id injectors have a great spray pattern and don't need the stock atomizers..
|
All times are GMT -5. The time now is 10:03 AM. |
© 2024 MH Sub I, LLC dba Internet Brands