Matrix Mode how to adjust in all cells? not just idle and 4000?
I switched all maps the same , but my matrix map only has values in the load (4000) and idle . My problem is i can not select any other cells to enter values
this is a LT10S running the 3.1 software. also tried it on 1.2 software wity same result if i try to use arrows to move to say 5000 table it just goes to the next screen the car had a decent normal mode tune from previos owner, but i changed fuel injectors and switching from e 85 to e 70. i want to tune it in matrix mode for hopefully a better result. thank you john |
Unfortunately, Matrix mode doesn't allow any adjustments below 4k. From what i understand, you should get the car running well below 4000 in normal mode, switch all maps the same, then move to matrix mode tune.
|
My problem is I can’t highlight any of the cells above or below the load(4000) rpm . I can freely move in only those cells or idle cells and that’s it maybe I’ll message Microtech Also should be able to adjust below 4000 cause u lose the rpm crs function of normal mode john |
Well I’m a dumbass I read the the user manual a littl more and found where to switch to matrix mode. So far I just copied my main load map for all the rpm so there are values in every cell and made adjustments where rpm wot and cars would have been , when there weather gets better I will start tuning. |
All times are GMT -5. The time now is 11:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands