Microtech Matrix Mode how to adjust in all cells? not just idle and 4000?
02-17-19, 02:30 PM
#1
Full Member
Thread Starter
Matrix Mode how to adjust in all cells? not just idle and 4000?
I switched all maps the same , but my matrix map only has values in the load (4000) and idle . My problem is i can not select any other cells to enter values
this is a LT10S running the 3.1 software.
also tried it on 1.2 software wity same result
if i try to use arrows to move to say 5000 table it just goes to the next screen
the car had a decent normal mode tune from previos owner, but i changed fuel injectors and switching from e 85 to e 70. i want to tune it in matrix mode for hopefully a better result.
thank you
john
this is a LT10S running the 3.1 software.
also tried it on 1.2 software wity same result
if i try to use arrows to move to say 5000 table it just goes to the next screen
the car had a decent normal mode tune from previos owner, but i changed fuel injectors and switching from e 85 to e 70. i want to tune it in matrix mode for hopefully a better result.
thank you
john
02-18-19, 10:29 AM
#3
Full Member
Thread Starter
My problem is I can’t highlight any of the cells above or below the load(4000) rpm . I can freely move in only those cells or idle cells and that’s it
maybe I’ll message Microtech
Also should be able to adjust below 4000 cause u lose the rpm crs function of normal mode
john
maybe I’ll message Microtech
Also should be able to adjust below 4000 cause u lose the rpm crs function of normal mode
john
02-28-19, 06:03 AM
#4
Full Member
Thread Starter
Well I’m a dumbass I read the the user manual a littl more and found where to switch to matrix mode. So far I just copied my main load map for all the rpm so there are values in every cell and made adjustments where rpm wot and cars would have been , when there weather gets better I will start tuning.
Thread
Thread Starter
Forum
Replies
Last Post
cbrock
Microtech
6
08-29-10 03:35 PM
