LTX-12s fuel issue.
Hey people, i have a peripheral ported N/A 13B Mazda RX7, a '90 Gen II. We have a Mircotech LTX-12s fitted, 4x RC 750 injectors, 4 x Gen3 FD coils. All
sensors are ok and correct, no fault lights on. I'm having an issue getting the car to fire up. I have set the ECU to the setting stated in the manual. Config: 4cyl Imput trig: + POS Output: - Dwell Type: Time Dwell : 3.25ms Pump Dwell: 3.50ms Now when in config and set to test all injectors fire fine and all plugs have good spark. Timing is set up to stock configuration. And i have good fuel pressue in the lines. The problem i'm having is when i crank the engine the injectors arn't firing at all. No fuel is comming out of them. The ECU was on a 20B n/a before. I was hoping that you may be able to direct to 'master' reset so i can start over from scratch. Alturnitively is there a way of telling the injectors to stop firing? maybe something have been altered by mistake. I do have the dash unit fitted in the car. Any help would be very much appriciated |
Send the ecu down to aus and have it reprogrammed for 13b.
pm me for more details. |
All times are GMT -5. The time now is 03:12 PM. |
© 2024 MH Sub I, LLC dba Internet Brands