LT-10s - How to select adjustment points
 

Hello guys,

I have a microtech LT-10 and the map I am using is configured to adjust the load and idle/aux maps in intervals reaching up to 20psi. I know that the internal MAP sensor is good to 25psi and I would like to play with/change the adjustment points so that I can adjust up to 25 psi.

Any ideas as to where this is done?

Thanks in advance!

Chris

you mean to tune matrix ???

No, I mean to change what points I can adjust at based on inHG/PSI...

Right now on the LOAD and Idle/AUX maps I can adjust fuel at 30, 25, 20, 15, 10, 05, 00, 02, 04, 08, 10, 12, 14, 16, 18, 20

I would like to space out the ones from 04-20 so that the last point is 25psi for example...right now I can only tune up to 20psi...

Is there a way to select which points/intervals I can tune at?

Thanks.

Chris

you cant changes the load points.

PS,, check again,, all the LT and LTX i know of actually lack a 12 psi map

you need the unit to be sent back to be re-configured for the 3 bar map sensor and this will change the spacing of the load plots larger to still have 15/16 cells