lm1 with lt10s
 

:scratch: :scratch: So the question could i use blue/red wire from lt10 with yellow wire on lm1 :Wconfused :Wconfused :Wconfused

you can wire it up but if your lt10 is not set up for a wide band o2 sensor then you are going to have to set the lm1 to output a narrow band signal

Which will be useless anyway.

Rx72 is correct just wanted to know if is possiable:icon_tup: :icon_tup:

Anybody successfully used their lc-1 or Lm-1 on the MT ecus with the narrow band setup to give a wideband reading?

how can somebody find out if the lt10 is setup for a wide band or not?

of course its possible. just gives you a bogus reading. not worth the effort.

As for checking if its programmed for wideband.
That i havnt had to do so wouldnt know.