Help?
I Just Bought The Lt10 And I Am Sodering The Tps Sensor Up But I See It Has 2 Ground Wires But The Instructions Say That It Should Be As Follows.
Green/green Check Red/red Check White/yellow Check White/black To Blue This Last One I Have Problems With I Have A Blue To Light Blue? |
What year of car? RX-7 I assume? Stock TPS?
|
88 turbo 2
|
IF it is s4
the blue wires goes to the orange wire on a s4 tps. the grey wire goes to the green wire on the tps. the brown wire goes to the black wire on the tps. i hope that helps. If it is s5. Its the same. But you only wire up one tps. the one closest to the alternator. you completely ignore the wiring of the other tps. |
Originally Posted by kingbob1000
(Post 8648404)
88 turbo 2
You'll find the wiring diagram in the Microtech manual. |
Aaron.
Have a look at the wires he described. Sounds alot like he is wiring the Crank Angle Sensor......... |
its not the crank angle sensor this tps sensor just had different colors than the manal described. i am wiring it to the clip not to the sensor right? the electrical system is far from my specialty. thanks again for the help
|
Post a picture.
|
So your wiring it to the wire plug on the loom side? not the tps side?
|
i am wiring it to the clip side. i am currently deploying to iraq next week so i am out in the feild training but i just wanted to get some advise for when i get back. thanks guys
|
All times are GMT -5. The time now is 11:33 AM. |
© 2024 MH Sub I, LLC dba Internet Brands