RotorsRulePistonsDrool |
09-09-11 01:34 PM |
Engine enters prime mode at 185f water temp...
At 185f water temp, my issues occur. For some reason every time i drive the car for about 45 minutes and the temp reaches 184-5 ish my wideband innovate guage flashes 7.4 (just like it does when I first turn on my microtech and power and fuel pump to prime the engine for first start). The temp does not increase much after the 7.4 "primer mode" and I do not feel any bogging or power changes... Have not run it long in this period to check for fouled plugs which would tell me that it actually is running rich or not. As soon as I turn the car off and on the "primer mode" is immediately gone. Anyone know what this is? or if its a setting in the microtech that I need to change?
I have read over the manual soo many times and have not found this issue addressed. Anyone know what it could be?
thanks
|