RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   Microtech (https://www.rx7club.com/microtech-111/)
-   -   Microtech Does LT8S Has a Default Setting? (https://www.rx7club.com/microtech-111/does-lt8s-has-default-setting-627014/)

andre sinclair 02-24-07 09:12 PM

Does LT8S Has a Default Setting?
 
Does LT8S Has a Default Setting?

Reason is that I was driving from my girl`s house on Saturday night early Sunday morning 4:00am and it was 45 degrees outside. Car drove well as it a new engine with 1500 miles, Compression is in the 7.5 cross the board in both rotors (hot tested).

So I stopped at Mobil and got gas. I usually premix 7 oz. per tank but i over poured to 14.5 oz. (not paying attention) Note the car gas gauge was bellow E when i stopped at the gas station.

started up normally and i drove for about 1-1/2 mile at 45mph, never hit boost at all and then all of a sudden the car just shut down. I got out and checked for spark as I had ample fuel pressure 40psi. (SPARK WAS PRESENT IN ALL COILS)

So I thought that the plugs were fouled out as I poured too much oil. I later installed new plugs and still no start. I then installed the hand held and check the values. The values had changed in almost all the MAPS from: water temp, cold start, crank, timing, loads, (screens- 23 to32) etc. I even notice that the pump settings in screen 19 had even changed. I just set everthing back as I had written them down after tuning and then she started. Car ran a little rough as if the TPS was set incorrectly. so i checked the TPS and it was on the money.

I have already drained the gas and refilled it was 110 octain (5 gallons) and then top up with 93 oct. Car runs good in boost and cruise etc. but when the load from the lights and Auto tranny it wants to die at idle.

Should i change my fuel filter? Or check for vacuum leaks?

Like i said compression is good 7.5 in both rotors (hot tested), pugs are new and spark is present in all coils.

So is there a default setting for the LT8s

If anyone has any idea as to what this can be I greatly appreciate it, Nevertheless, I can explain this much better over the phone if anyone is willing to call, or you can PM me and I`ll gladly call you.

Thanks,

Andre
561 716 2678

andre sinclair 02-25-07 06:58 PM

Got it Fixed today... Thanks

boosted1205 03-04-07 02:38 PM


Originally Posted by andre sinclair
Got it Fixed today... Thanks

So what was the problem?


All times are GMT -5. The time now is 06:59 AM.


© 2024 MH Sub I, LLC dba Internet Brands