Diagram error in ignition wiring or harness error?
I just took a look at my LT8 harness and I noticed that for some reason, there's a discrepency with the ignition wiring, or my harness.
Microtech's diagram shows: Grey/Red - Ignition ouput #4 Grey/Black - Ignition output #3 According to the image that provides the pinout, these would be the CENTER two pins of the 6pin connector. Now, on my harness, the GREY/BLACK and the GREY/RED are wired on the outside (left most) of that connector, which would make it instead: Grey/Red - ignition output #2 Grey/BLACK - Ignition output #1 So, is my harness incorrect, or is the diagram incorrect? Should I be using the middle pins for trailing, or the outside? |
Damn, can't attach images in this section?
|
Hey Sonic, awlright dude I just ran out to my car with MT ignition drawing in hand and yes...it sounds like your harness is wrong.
Looking at the back of the connector (wires coming from the harness): grey/black - bottom middle (ign output 3) grey/red - top middle (ign output 4) grey/blue - top right (ign output 0) I hope that helps. -John |
Thanks, exactly what I needed!
|
Glad I could help!
-John |
Originally Posted by TwistedRotors
(Post 4922640)
Hey Sonic, awlright dude I just ran out to my car with MT ignition drawing in hand and yes...it sounds like your harness is wrong.
Looking at the back of the connector (wires coming from the harness): grey/black - bottom middle (ign output 3) grey/red - top middle (ign output 4) grey/blue - top right (ign output 0) I hope that helps. -John hi there this has also just helped me thank u but i also i must ask i have a fd is this using fc coils 13bt thanks |
All times are GMT -5. The time now is 09:54 AM. |
© 2024 MH Sub I, LLC dba Internet Brands