calibrating the tps.
 

I was calibrating the tps, and the max % that I see is 59. Any problem with this

What TPS are you using? I am about to hook up a LT8S with a S4 partial range TPS and was wondering about this issue. too.

Somebody?

I am calibrating with the full range./

you have the tps wired incorrectly, try swapping the wires around and it will read correctly

Dale

damn I kinda knew it, what is the correct wiring for the full range?

check in the wiring digrams,

you wont damage anything by swapping the wires around, so if your sensor isnt on the wiring digram just keep swapping them over till it is right

dale

Tps
 

Try this:
Looking at sensor
Blue (5V) at terminal #1
Broun (GND) at terminal # 3
Grey (SIG) at terminal # 4
Let me know

can you tell me with the color of the tps wires? I removed the main connector cus since I have an s4 I connected the switch type and used the stock connector.

BOB

What is up my rotary brother! Got that Mictrotec I see. Hope it goes smooth because I will be riding in that beast come November. Video action is comming. :0 Peace out, email me.

No, but if your TPS have 4 connector (because is for one with 4 connector) stars at one side for #1 and if it's not "OK" start at the other side with #1.

no my tps, like any other s4/s5 tps has 3 wires. Thanks anyways..