Best way to wire my LT10s?
 

Should I use a Microtech harness or should I wire it on my own? Where can I get the harness for the LT10, I haven't seen one on Microtech's website.

Pardon my ignorance, and thanks,

Carl

You should be able to order the harness from any Microtech dealer (like Aspec). Yes, you should start with a new Microtech harness unless your stock harness is in extraordinarily good condition.

The Microtech harness is about $200.

Hey Aaron, do you know if it's possible to order just a pin kit, or are they just standard pins?

Same pins as used on ATX computer power supplies, so any electronics store should have it in stock or be able to get it...

I found this out when I started constructing a Microtech-harness to Megasquirt adapter. Same plug as an ATX computer supply...

Great, thank you.

Is Aspec canadian? My engine harness is pretty old and crusty so I think I'll pick one up. Do you have thier website?

They don't seem to show any Microtech stuff on their website now, but that's where I've always bought my Microtech products.

http://www.a-spectuning.com/products.htm

Does anybody have a spare 6-pin harness out of the X4 box?

Those aren't very common, you might as well open her up and solder in your own connector (some type of Molex type piece)